How do I perform routine cleaning and maintenance of the cyclone assembly, front fan filter, and dust cup?
1. Press the Dumping button at the end of the main unit to release the dust cup. Open the bottom lid of the cup to dump the waste. 2. Rotate and remove the dust cup. 3. Take out the front fan filter and cyclone assembly. 4. Rinse each part. 5. Dry the dust cup, front fan filter, and cyclone assembly for at least 24 hours until they are completely dry. ( Notes: Do not dry the dust cup, front fan filter, or cyclone assembly in a cylinder dryer, oven, microwave oven, or near an open fire. Rinse the filter with tap water at least once a month. Clean the dust cup immediately when the dust reaches the "MAX" mark. Otherwise, the vacuuming performance will be compromised. Do not use detergents, polishes, or air fresheners to clean the dust cup. Do not clean the dust cup, fan, front fan filter, or cyclone assembly in a dishwasher or other equipment. Do not disassemble the double-layer multi-cone filter parts to avoid unnecessary damage.)
How to Install the Cyclone Assembly, Front Fan Filter, and Dust Cup?
1. Align the latch at the edge of the cyclone assembly with the notch on the dust cup and press to the bottom. 2. Place the handle side of the front fan filter outwards and press to the bottom. 3. Align the protruding latch on the main unit with the notch of the appropriate size on the dust cup and rotate to lock the cup. (Make sure that the rear fan is ejected when rotating the dust cup.) 4. Press down on the dust cup until it clicks into position. (Watch out for pinching when pressing.)
How to Maintain the Rear Fan Filter?
1. Rotate the rear filter assembly counter-clockwise to remove it. Rotate counterclockwise again to remove the rear fan filter. 2. Rinse the rear fan filter. Leave it to dry for at least 24 hours. 3. Rotate the rear fan filter clockwise to install it. 4. Rotate clockwise again to install the rear filter assembly.
The electric brush does not rotate?
1. The brush is jammed. Remove any foreign objects and try again. 2. Overheating protection is activated for the motor. Wait until the brush cools down and try again. 3. The electric brush is conductive or dirty. Wipe the brush with a soft dry cloth and try again.
The fan does not rotate?
1. The battery level is low. Charge before use. 2. The device is used for so long that overheating protection is activated. Restart after it cools down. 3. The filter or suction head gets blocked. Clean the filter and suction head immediately.
The air duct is blocked?
1. The dust cup is full or the filter element is blocked. Clean the dust cup and filter. 2. The brush gets blocked. Clean the brush.
The brush does not rotate?
The PTC-locked rotor protection is activated. Clean any foreign objects and restart.