Name: Matek 8 Bit WS2812B RGB 5050 Highlight LED for Naze32 CC3D
Brand: Other
SKU: 368188
Price: 5.79 USD
Availability: InStock

Ship to:

United States

Select the desired shipping method

*Please note: the shipping costs are only estimates; the actual shipping price will be shown on the order page.

0 item(s) added

View CartContinue Shopping

Sold Out

Highlights

Built-in controller chip, only need an IO port to control multiple LED.
Chip built-in shaping circuit,signal distortion is not cumulative, stable display.
Trichromatic 256 brightness adjustment, scan frequency is not less than 400Hz / S.
Serial connection-level interface, through a signal line to finish receiving and decoding data.
Both ends have interfaces (DIN DOUT) that can be cascaded
Will show the flight control lock / unlock,left and right aileron, brake, throttle, alarm and other status.

Specification

General
Type	LED
Voltage	About 5V
Ports	Digital
Size	51x10mm
Compatible	AVR, Arduino,Naze32 / CC3D Flight Control
Note	If it is used for Naze32 or CC3D flight control,it need to brushed CleanFlight, and using PPM receivers. CC3D flight controller notes: CC3D need to brushed CleanFlight firmware. Using PPM / SBUS receiver, you don’t use PWM receiver. GND 5V DIN behind the lights should connected to CC3D fifth row - + S of the motor output side. Choosing PPM receiver in the CF's assistant software configuration,then choose LED_STRIP options. Finally into the CF assistant software LED Strip Page to setup various states.
Package Contents
1x WS2812B RGB 5050 LED